The Comparison of Output Characteristics in Electrical Discharge machining and Aluminum Powder Mixed EDM Processes on Titanium Aluminide Intermetallic Compound

Volume 4, Issue 1, September 2017, Pages 25-37

• View Article
• PDF 1.38 M

A numerical-experimental investigation on spring back in rectangular section thin wall hollows and extracting a relation to estimate twisted angle by considering strain harden behavior

Volume 4, Issue 1, September 2017, Pages 38-43

Mohammad Kashfi; Davood Bakhtiyari; Ataollah Ghavamian; Mohsen Kashfi; Parviz Kahal

• View Article
• PDF 497.41 K

Mechanical behavior of Fe/ TiC surface layer fabricated by SMAW process

Volume 4, Issue 1, September 2017, Pages 44-53

• View Article
• PDF 2.17 M

Effect of ultrasonic on hot compaction of AA1100 and Ti-6Al-4V powders

Volume 3, Issue 3, February 2017, Pages 1-12

• View Article
• PDF 907.77 K

Investigation of Galling wear on stamping dies due to work with advances high strength steel sheets

Volume 3, Issue 3, February 2017, Pages 13-19

• View Article
• PDF 552.97 K

Experimental investigation and numerical modelling of dynamic compaction process of pure iron powder with ceramic particles

Volume 3, Issue 3, February 2017, Pages 20-28

• View Article
• PDF 829.62 K

Experimental Study of Material Removal Rate, Surface Roughness and Topography in Electrical Discharge Machining of Titanium Aluminide Intermetallic Compound

Volume 3, Issue 3, February 2017, Pages 29-39

• View Article
• PDF 1.98 M

Plastic deformation behavior of Aluminum 5452 alloy under unconstrained high pressure torsion and effect of turns and applied pressures on their r*

Volume 3, Issue 3, February 2017, Pages 40-47

• View Article
• PDF 763.79 K

Simulation and study of polishing of special curvature based forging die by using abrasive flow machining

Volume 3, Issue 3, February 2017, Pages 48-57

• View Article
• PDF 956.42 K